
For NEBULITE Smart Controllers with Wi-Fi that still run WLED, for example in crop tops, vests and jackets, and for HELIO 1. The NEBULITE | HELIO app updates them to MoonLight, and afterwards you control them in the app.
Not sure what your piece has? If it opens its own Wi-Fi network named NEBULITE-…, or its controls open at 4.3.2.1 in a browser, its controller runs WLED and this guide is for you.
Important: hold the button
On the NEBULITE S3 with battery, the Standby button (the left button) has to stay pressed for the whole update. The easiest way is a clothespin: clamp it on the button before you start and leave it there until the update has finished. Then take it off. If the controller stays dark afterwards, press Standby once.

| Controller | Button | What to do |
|---|---|---|
| NEBULITE S3 (battery) | Standby, the left button | Keep it pressed for the whole update, ideally with a clothespin |
| NEBULITE ESP32 | None | Leave the buttons as they are |
| HELIO 1 | None | Leave the buttons as they are. HELIO runs from the mains |
The app recognises your controller and asks for the clothespin only when it is needed.
Before you start
- Power the controller and keep it switched on during the whole update.
- Put your phone on the same Wi-Fi as the controller: your home Wi-Fi, or the controller’s own network (its name starts with NEBULITE-, the password is nebulite).
- MoonLight starts fresh: patterns and settings from WLED are not kept.
Update
- Open NEBULITE | HELIO and tap Find Wi-Fi on the Home screen.
- If the controller shows old WLED firmware, tap Update to MoonLight.
- Keep the controller powered, the screen open and your phone on this Wi-Fi. It takes about a minute.
- Afterwards the controller connects over Bluetooth. Open it on the Home screen and choose which product it is.
If something isn’t working
The app says the controller needs the USB installer
Email support@nebulite.berlin with a photo of the controller label. We’ll help you with the update.
The app can’t find the controller
Check that your phone and the controller are on the same Wi-Fi, then tap Find Wi-Fi again.
Still stuck?
Email support@nebulite.berlin with a photo of the controller label, your phone model and what you've tried so far.
